MIL-PRF-94G
APPENDIX A
PROCEDURE FOR QUALIFICATION INSPECTION
A.1. SCOPE
A.1.1 Scope. This appendix details the procedure for submission of samples, with related data, for qualification
inspection of category I resistors covered by this specification. The procedure for extending qualification of the required
sample to other resistors covered by this specification is also outlined herein. This appendix is a mandatory part of this
specification. The information contained herein is intended for compliance only.
A.2 APPLICABLE DOCUMENTS
A.2.1 Government documents.
A.2.1.1 Specifications, standards, and handbooks. The following specifications, standards, and handbooks form a
part of this document to the extent specified herein. Unless otherwise specified, the issues of these documents are
those cited in the solicitation (see 6.2).
DEPARTMENT OF DEFENSE STANDARDS
MIL-STD-1276
-
Leads for Electronic Component Parts
(Copies of these documents are available online at https://assist.daps.dla.mil/quicksearch/ or https://www.dodssp.daps.mil
or from the Standardization Document Order Desk, 700 Robbins Avenue, Building 4D, Philadelphia, PA 19111-5094).
A.2.2 Order of precedence. In event of a conflict between the text of this document and the references cited
herein (except for related associated specifications, specification sheets, or MS sheets), the text of this document
takes precedence. Nothing in this document, however, supersedes applicable laws and regulations unless a specific
exemption has been obtained.
A.3. SUBMISSION
A.3.1 Sample
A.3.1.1 Single type submission. A sample consisting of 56 sample units of each type for which qualification is
sought shall be submitted in accordance with table A-I. All sample units shall have 0.875 inch (22.23 mm) shaft
lengths.
A.3.1.2 Combined type submission. For qualification of either the standard bushing or the locking bushing type
resistors, a sample consisting of the number of sample units specified in table A-I shall be submitted in each style and
moisture resistance characteristic for which qualification is sought. To receive qualification of locking bushing type
resistors when standard bushing type resistors have been submitted, an additional sample of locking bushing type
resistors shall be submitted. This sample shall consist of the number of sample units specified in table A-II and shall
have a resistance value equal to the critical value as specified in table A-III. All sample units shall have 0.875 inch
(22.23 mm) shaft lengths.
A.3.2. Test results. Each submission shall be accompanied by test results covering the nondestructive tests listed
in table VIII or IX which have been performed on the submitted sample units. The performance of the destructive
tests by the supplier on a duplicate set of sample units is encouraged, although not required. All test results shall be
submitted in duplicate. Qualification of the switch in any style will qualify switches in all other styles. Approval of
resistors with slotted shafts shall be the basis for approval of flatted shafts. Approval of flatted shafts will be basis for
approval of slotted shafts.
27
For Parts Inquires call Parts Hangar, Inc (727) 493-0744
© Copyright 2015 Integrated Publishing, Inc.
A Service Disabled Veteran Owned Small Business