INCH-POUND
MIL-PRF-49462C
17 April 2008
SUPERSEDING
MIL-PRF-49462B
12 February 2001
PERFORMANCE SPECIFICATION
RESISTORS, FIXED, FILM, HIGH VOLTAGE
GENERAL SPECIFICATION FOR
This specification is approved for use by all Departments
and Agencies of the Department of Defense.
1. SCOPE
1.1 Scope. This specification covers the general requirements for fixed, film, high voltage resistors
primarily intended for incorporation into electronic circuits where high voltages and high resistance values
are present.
1.2 Classification.
1.2.1 Part or Identifying Number (PIN). The PIN is in the following form, and as specified (see 3.1).
A
A
100K
F
M4946203
⏐
⏐
⏐
⏐
⏐
⏐
⏐
⏐
⏐
⏐
Specification and
Characteristic
Style
Resistance
Tolerance
associated slash sheet
(1.2.1.1)
(1.2.1.2)
(1.2.1.3)
(1.2.1.4)
1.2.1.1 Characteristic. The characteristic is identified by a single letter A, in accordance with table I.
1.2.1.2 Style. The style is identified by a single letter (see 3.1). The styles available are A, B, C, D, E,
and F.
1.2.1.3 Resistance. The nominal resistance expressed in ohms is identified by four characters, consisting of
three digits and a letter. The letter is used simultaneously as a decimal point and as a multiplier. For resistance
values:
a. Greater than or equal to 1 ohm but less than 1 kilohm, the letter "R" is used to represent a decimal
point.
b. Greater than or equal to 1 kilohm but less than 1 megohm, the letter "K" is used to represent a
decimal point.
Comments, suggestions, or questions on this document should be addressed to: Defense Supply Center, Columbus
ATTN: DSCC-VAT, Post Office Box 3990, Columbus, Ohio 43218-3990, or emailed to resistor@dla.mil. Since
contact information can change, you may want to verify the currency of this address information using the ASSIST
Online database at https://assist.daps.dla.mil.
AMSC N/A
FSC 5905
For Parts Inquires call Parts Hangar, Inc (727) 493-0744
© Copyright 2015 Integrated Publishing, Inc.
A Service Disabled Veteran Owned Small Business