MIL-R-26-6 Resistor, Fixed, Wire Wound Power Type, Styles Rw80 And Rw81This specification covers the associated requirements for styles RW80 and RW81, wirewound inductive resistors.

Pages 1 - 2 - 3 - 4 - 5 - 6 - 7

MIL-R-26/6D

2.2  Government documents.

2.2.1  Specifications, standards, and handbooks.  The following specifications, standards, and handbooks form a part of this document to the extent specified herein.  Unless otherwise specified, the issues of these documents are those cited in the solicitation or contract (see 6.2).

DEPARTMENT OF DEFENSE SPECIFICATION

MIL-PRF-26          -            Resistors, Fixed, Wire Wound (Power Type), General Specification for. (Copies of these documents are available online at https://assist.daps.dla.mil/quicksearch/ or

https://assist.daps.dla.mil or from the Standardization Document Order Desk, 700 Robbins Avenue, Building 4D, Philadelphia, PA 19111-5094).

2.3  Order of precedence.  In the event of a conflict between the text of this document and the references cited herein, the text of this document takes precedence.  Nothing in this document, however, supersedes applicable laws and regulations unless a specific exemption has been obtained.

3.  REQUIREMENTS

3.1  General.  The requirements for acquiring the product described herein shall consist of this document and MIL-PRF-26.

3.2  Interface and physical dimension.  The resistor shall meet the interface and physical dimensions specified on figure 1 and as specified herein.

3.3  Power rating and maximum voltage.  The power rating and maximum continuous voltage (dc or rms, ac) shall be in accordance with table III.  The power rating shall be based on full-load operation at an ambient temperature of 25OC.

TABLE III.  Power rating and maximum voltage.

3.4     Resistance.  The minimum and maximum nominal resistance values shall be as specified in table IV.

3.4.1  Standard resistance values.  For standard resistance values see MIL-PRF-26.

TABLE IV.  Minimum and maximum nominal resistance values.

3