INCH-POUND
MIL-PRF-914/1A
3 July 1997
SUPERSEDING
MIL-R-914/1
12 February 1991
PERFORMANCE SPECIFICATION
RESISTOR NETWORK, FIXED, FILM,
SURFACE MOUNT, 14-PIN, SMALL OUTLINE,
NONESTABLISHED RELIABILITY AND ESTABLISHED RELIABILITY,
STYLE RNS010
This specification is approved for use by all Departments
and Agencies of the Departments of Defense.
1. SCOPE
1.1 Scope. This specification covers the associated requirements for the style RNS010 resistor
networks. The established reliability (ER) and nonestablished reliability (non-ER) styles are available for
characteristic R, characteristic V, characteristic H,characteristic K, and characteristic M and all resistance
tolerances.
1.2 Part or Identifying Number (PIN) (see 6.4). Resistor networks covered by this specification is
identified by a PIN which consists of the basic number of this specification and a coded number. The PIN is
in the following form:
M914J01
H1002FAS
-----------------
-------------------
Associated
Coded number
specification
The coded number is derived in accordance with MIL-PRF-914.
1.2.1 Schematic. The schematic of the resistor network is identified by a single letter in accordance with
figure 1. The resistor element Ref is the reference resistor element used in determining the ratio accuracy
(when applicable).
Beneficial comment (recommendations, additions, deletions) and any pertinent data which may be of
use in improving this document should be address to: US Army Communications - Electronics
Command, ATTN: AMSEL-LC-LEO-E-EP, Fort Monmouth, NJ 07703-5023 by using the
Standardization Document Improvement Proposal (DD Form 1426) appearing at the end of this
document or by letter.
AMSC N/A
FSC 5905
DISTRIBUTION STATEMENT A. Approved for public release; distribution is unlimited.
For Parts Inquires call Parts Hangar, Inc (727) 493-0744
© Copyright 2015 Integrated Publishing, Inc.
A Service Disabled Veteran Owned Small Business