MIL-PRF-55342-9 Resistors, Chip, Fixed, Film, Nonestablished Reliability, Established Reliability, Space Level Style Rm2512This specification covers the requirements for style RM2512, fixed, film, chip, nonestablished reliability, established reliability, and space level resistors. This style is available in characteristic H, characteristic E, characteristic K, characteristic L, and characteristic M, resistance tolerances .1 percent, .25 percent, .5 percent, 1 percent, 2 percent, 5 percent, and 10 percent, and all termination materials. Designers are CAUTIONED on using these resistors in high power pulses applications \(see 6.5\).

Pages 1 - 2 - 3 - 4 - 5

INCH-POUND

MIL-PRF-55342/9E

31 October 2003

SUPERSEDING

MIL-PRF-55342/9D

12 April 2002

PERFORMANCE SPECIFICATION

RESISTORS, CHIP, FIXED, FILM,

NONESTABLISHED RELIABILITY, ESTABLISHED RELIABILITY, SPACE LEVEL

STYLE RM2512

This specification is approved for use by all Departments

and Agencies of the Department of Defense.

1. SCOPE

1.1 Scope. This specification covers the requirements for style RM2512, fixed, film, chip, nonestablished reliability,

established reliability, and space level resistors. This style is available in characteristic H, characteristic E,

characteristic K, and characteristic M, resistance tolerances .1 percent, 1 percent, 2 percent, 5 percent, and 10

percent, and all termination materials except termination P.

1.2 Part or Identifying Number (PIN). Chip resistors covered by this specification are identified by a PIN which

consists of the basic number of this specification and a coded dash number. The PIN is in the following form:

M55342H09

B1E00M

Performance specification

Coded dash

number

The coded dash number is derived in accordance with MIL-PRF-55342.

2. APPLICABLE DOCUMENTS

2.1 General. The documents listed in this section are specified in sections 3 and 4 of this specification. This

section does not include documents cited in other sections of this specification or recommended for additional

information or as examples. While every effort has been made to ensure the completeness of this list, document

users are cautioned that they must meet all specified requirements documents cited in sections 3 and 4 of this

specification, whether or not they are listed.

Comments, suggestions, or questions on this document should be addressed to: US Army Communications -

Electronics Command and Fort Monmouth, ATTN: AMSEL-LC-LEO-E-EP, Fort Monmouth, NJ 07703-5023 or

emailed to Jeffery.Carver@mail1.monmouth.army.mil. Since contact information can change, you may want to

verify the currency of this address information using the ASSIST Online database at www.dodssp.daps.mil.

AMSC N/A

FSC 5905

DISTRIBUTION STATEMENT A. Approved for public release; distribution is unlimited.