MIL-PRF-26/3E
6. NOTES
(This section contains information of a general or explanatory nature that may be helpful, but is not
mandatory.)
6.1 Notes. In addition to the notes specified herein, the notes specified in MIL-PRF-26 are applicable to
this specification.
6.2 Acquisition requirements. Acquisition requirements are as specified in MIL-PRF-26.
a. Title, number, and date of this specification, and the complete PIN (see 1.2).
b. If not otherwise specified (see 2.1), the versions of the individual documents referenced will be
those in effect on the date of release of the solicitation.
c.
Packaging instructions (see 5.1).
d. Whether bracket assembly is required (see 6.4.1).
6.3 Supplementary insulation. Where potential to ground is over 500 volts, supplementary insulation
should be provided.
6.4 Mounting. These resistors should not be mounted by their terminals.
6.4.1 Bracket assemblies. When required, bracket assemblies (mounting hardware) are available for
these resistors under MS75009, Bracket Assembly, Resistor (Power type).
6.5 Derating. Resistors shall be derated, when necessary, in accordance with figure 2.
6.6 Changes from previous issue. Changes from previous issue. The margins of this specification are
marked with vertical lines to indicate where changes from the previous issue were made. This was done
as a convenience only and the Government assumes no liability whatsoever for any inaccuracies in these
notations. Bidders and contractors are cautioned to evaluate the requirements of this document based on
the entire content irrespective of the marginal notations and relationship to the last previous issue.
7
For Parts Inquires call Parts Hangar, Inc (727) 493-0744
© Copyright 2015 Integrated Publishing, Inc.
A Service Disabled Veteran Owned Small Business