MIL-R-18546-1 Resistors, Fixed, Wire-Wound Power Type, Chassis Mounted, Styles Re60, Re65, Re70, And Re75This specification covers the requirements for styles RE60, RE65, RE70, and RE75 resistors.

Pages 1 - 2 - 3 - 4 - 5 - 6 - 7 - 8

MIL-R-18546/1G

SPECIFICATION

DEPARTMENT OF DEFENSE

MIL-PRF-18546       -  Resistors, Fixed, Wire-Wound, (Power Type, Chassis Mounted), General Specification for.

(Unless otherwise indicated, copies of the above specifications, standards, and handbooks are available from the Document Automation and Production Service, Building 4D (DPM-DODSSP), 700

Robbins Avenue, Philadelphia, PA 19111-5094.)

2.3  Order of precedence.  In the event of a conflict between the text of this document and the references cited herein, the text of this document takes precedence.  Nothing in this document, however, supersedes applicable laws and regulations unless a specific exemption has been obtained.

3.  REQUIREMENT

3.1  General.  The requirements for acquiring the product described herein shall consist of this document and MIL-PRF-18546.

3.2  Interface and physical dimension.  Resistors shall meet the interface and physical dimension specified on figure 1 and as specified herein.

3.2.1  W eight.  The maximum weight shall be as specified in table I.

TABLE I.  W eight.

3.3  Power rating.  The power rating shall be as specified in table II, based on full load operation at an ambient temperature of 25 C, when mounted on the chassis specified in table VI.

TABLE II.  Power rating.

1/  Free air power ratings are listed for information only.

2