MIL-PRF-94-6 Resistors, Variable, Composition, Style 2Rv7This specification covers the detail requirements for style 2RV7 composition, variable, dual \(2 ganged\) resistor.

Pages 1 - 2 - 3 - 4 - 5 - 6 - 7

MIL-PRF-94/6E

TABLE I. Shaft length. 1/

Length of shafts from mounting surface of resistors,

(nominal)

Flatted

Slotted

Symbol

Bushings N and S

Bushings L and T

(inches �0.313)

0.625

0.500

0.875

1.250

1.500

2.000

2.500

For resistors with panel seals, the mounting surface shall be considered the

metal face of the panelseal when the seal is firmly seated against the resistor

body.

1.2.1.7 Resistance characteristic combinations. The resistance characteristic combination is identified by a single

letter which describes a combination of resistance characteristic symbols per MIL-PRF-94, as specified in table II.

TABLE II. Resistance characteristics combination symbol.

Resistance characteristic symbol

Resistance characteristic

combination symbol

Panel cup

Rear cup

2. APPLICABLE DOCUMENTS

2.1 General. The documents listed in this section are specified in sections 3 and 4 of this specification. This

section does not include documents cited in other sections of this specification or recommended for additional

information or as examples. While every effort has been made to ensure the completeness of this list, document

users are cautioned that they must meet all specified requirements documents cited in sections 3 and 4 of this

specification, whether or not they are listed.

2.2 Government documents.

2.2.1 Specifications, standards, and handbooks. The following specifications, standards, and handbooks form a

part of this document to the extent specified herein. Unless otherwise specified, the issues of these documents are

those cited in the solicitation (see 6.2).

DEPARTMENT OF DEFENSE SPECIFICATION

Resistor, Variable, Composition, General Specification for.

or from the Standardization Document Order Desk, 700 Robbins Avenue, Building 4D, Philadelphia, PA 19111-5094).