MIL-PRF-39035/1E
2.2 Government documents.
2.2.1 Specifications, standards, and handbooks. The following specifications, standards, and handbooks form a
part of this document to the extent specified herein. Unless otherwise specified, the issues of these documents are
those cited in the solicitation or contract (see 6.2).
DEPARTMENT OF DEFENSE SPECIFICATION
-
Resistors, Variable, Nonwirewound (Adjustment Type),
Nonestablished Reliability, and Established Reliability, General
Specification for
(Copies of these documents are available online at https://assist.daps.dla.mil/quicksearch/ or
https://assist.daps.dla.mil or from the Standardization Document Order Desk, 700 Robbins Avenue, Building 4D,
Philadelphia, PA 19111-5094).
2.3 Order of precedence. In the event of a conflict between the text of this document and the references cited
herein (except for related specification sheets), the text of this document takes precedence. Nothing in this
document, however, supersedes applicable laws and regulations unless a specific exemption has been obtained.
3. REQUIREMENTS
3.1 General. The requirements for acquiring the product described herein shall consist of this document and
3.2 Interface and physical dimension requirements. Resistors shall meet the interface and physical dimensions
specified on figure 1.
3.3 Power rating. The power rating shall be 3/4 watt.
3.4 Terminals. All characteristics are available with L- and Y- type terminals.
3.5 Nominal resistance value and maximum rated ac or dc working voltage. Nominal resistance values and
maximum rated ac or dc working voltages shall be as specified in table I.
3.5.1 Resistance value deviations. All maximum deviations as specified in this section are to be considered
absolute limits with the exception of the contact resistance adjustments.
3.6 Actual effective electrical travel. Actual effective electrical travel shall be 17 turns minimum, and 27 turns
maximum.
3.7 Operating torque. Operating torque shall be a maximum of 8 ounces-inches.
3.8 Maximum voltage. Maximum rated ac or dc working voltage shall be 300 volts.
3.9 Pure tin. The use of pure tin, as an underplate or final finish, is prohibited both internally and externally. Tin
content of resistor components and solder shall not exceed 97 percent, by mass. Tin shall be alloyed with a minimum
of 3 percent lead, by mass (see 6.3).
3.10 Weight. The weight is .159 ounces (4.5 grams).
2
For Parts Inquires call Parts Hangar, Inc (727) 493-0744
© Copyright 2015 Integrated Publishing, Inc.
A Service Disabled Veteran Owned Small Business