, nonestablished reliability, established reliability, accurate, wire-wound, fixed resistors.

Pages 1 - 2 - 3 - 4 - 5 - 6

MIL-PRF-39005/11C

3.12 Marking. Due to size limitations, style RBR80 resistor shall be marked with the following

minimum information:

BR80L - Partial style and terminal designator

12701 - Coded resistance value

FMJ - Tolerance, failure rate, JAN marking

7445A - Date code, lot code

The complete marking is required on the unit package. Where manufacturers are able to provide more

information, the following is preferred in the sequence presented: Style and source code.

4. VERIFICATION

4.1 Classification of inspection. The inspection requirements specified herein are classified as follows.

4.2 Qualification inspection. Qualification inspection shall be in accordance with MIL-PRF-39005. In

addition, following the completion of group V of table VII, the 30 samples shall be tested as specified in

4.4, herein, with zero defectives allowed.

4.3 Conformance inspection. Sampling and inspection shall be in accordance with MIL-PRF-39005. In

addition, prior to subjection the 102 sample units to the annual group C (table X) "High temperature

exposure" test, 30 of these samples (10-high value, 10-10,000 ohms, 10-low value) will be tested as

specified in 4.4, herein, with zero defectives allowed.

4.4 Maximum allowable reactance. The inherent reactance shall be measured as follows:

a. Test instrument: Hewlett-Packard RX meter, model 250B; Tektronic LC meter, type 130, or any

other equivalent meter.

b. Frequency range: 100 kHz to 500 kHz.

5. PACKAGING

5.1 Packaging. For acquisition purposes, the packaging requirements shall be as specified in the

contract or order (see 6.2). When packaging of materiel is to be performed by DoD or in-house

contractor personnel, these personnel need to contact the responsible packaging activity to ascertain

packaging requirements. Packaging requirements are maintained by the Inventory Control Point's

packaging activities within the Military Service or Defense Agency, or within the military service's system

commands. Packaging data retrieval is available from the managing Military Department's or Defense

Agency's automated packaging files, CD-ROM products, or by contacting the responsible packaging

activity.

6. NOTES

(This section contains information of a general or explanatory nature that may be helpful, but is not

mandatory.)

6.1 Notes. The notes specified in MIL-PRF-39005 are applicable to this specification.