Degrees C depending upon the resistance value. They are not capable for application when the alternating current \(ac\) characteristics are of critical importance; however, provisions have been made to minimize the inductance.

Pages 1 - 2 - 3 - 4 - 5 - 6 - 7 - 8 - 9 - 10 - 11 - 12 - 13 - 14 - 15 - 16

MIL-PRF-18546G

APPENDIX A

PROCEDURE FOR QUALIFICATION INSPECTION

A.1 SCOPE

A.1.1 Scope. This appendix details the procedure for submission of samples for qualification

inspection of resistors covered by this specification. The procedure for extending qualification of the

required sample to other resistors covered by this specification is also outlined herein. This appendix is a

mandatory part of this specification. The information contained herein is intended for compliance only.

A.2 APPLICABLE DOCUMENTS

A.2.1 General. The documents listed in this section are specified in sections A.3, A.4, and A.5 of this

specification. This section does not include documents cited in other sections of this specification or

recommended for additional information or as examples. While every effort has been made to ensure the

completeness of this list, document users are cautioned that they must meet all specified requirements

documents cited in section A.3, A.4, and A.5 of this specification, whether or not they are listed.

A.2.2 Government documents.

A.2.2.1 Specifications, standards, and handbooks. The following specifications, standards, and

handbooks form a part of this document to the extent specified herein. Unless otherwise specified, the

issues of these documents are those cited in the solicitation or contract.

DEPARTMENT OF DEFENSE STANDARDS

Leads for Electronic Components Parts.

(Copies of these documents are available online at https://assist.daps.dla.mil/quicksearch/ or

https://assist.daps.dla.mil or from the Standardization Document Order Desk, 700 Robbins Avenue,

Building 4D, Philadelphia PA 19111-5094.)

A.2.3 Order of precedence. In the event of a conflict between the text of this document, and the

references cited herein (except for specification sheets) the text of this document takes precedence.

Nothing in this document, however, supersedes applicable laws and regulations unless exemption has

been obtained.

A.3 SUBMISSION

A.3.1 Sample. A sample consisting of 18 coated or enclosed and 4 uncoated or unenclosed sample

units, of the highest resistance value, and in addition, a sample consisting of 4 coated or enclosed sample

units of any resistance value, shall be submitted for each style and characteristic for which qualification is

sought. If the same coating or enclosure is not used, a separate sample shall be submitted for each

coating and enclosure for which qualification is sought. Samples shall be representative of the supplier's

normal production.