A-A-55088 Resistors, Flameproof, FusibleThis \(CID\) covers the general requirements for flameproof, fusible resistors. These resistors act as a wire-wound resistor and a fuse, and are used in applications where precise control of fusing point and time lags are necessary. These resistors eliminate fire hazard and circuit board damage due to overheated components. Resistors covered by this CID are intended for commercial/industrial applications and are not used in military systems needing stringent environmental and electrical requirements.

Pages 1 - 2 - 3 - 4 - 5 - 6

A-A-55088C

7.4 Source of documents.

FEDERAL REGULATIONS

- Federal Acquisition Regulations (FAR) � Use of Recovered Materials.

(Copies of these documents are available online at www.acquisition.gov/comp/far/index.html or from the

U. S. Government Printing Office, 732 North Capital Street, NW Washington D.C. 20401.)

7.5 Ordering data. The contract or order should specify the following:

a. CID document number, revision, and CID PIN.

b. Product conformance provisions.

c. Packaging requirements.

7.6 Commercial products. As part of the market analysis and research effort, this CID was coordinated

with the following manufacturers of commercial products. At the time of CID preparation and

coordination, these manufacturers were known to have commercial products that would meet the

requirements of this CID. (NOTE: This information should not be considered as a list of approved

manufacturers or be used to restrict procurement to only the manufacturers shown).

MFR's CAGE

MFR's name and address

IRC, Incorporated

54294

Wirewound and Film Technologies Division

736 Greenway Road

Boone, North Carolina 28607-1860

Phone:828-264-8861

Fax:828-264-8866

RCD Components, Incorporated

56637

520 East Industrial Park Drive

Manchester, NH 03109-5316

Phone: (603) 669-0054

Fax: (603) 669-5455

7.7 Part number (P/N) supersession data. This CID supersedes the following manufacturers P/N as

shown in table II. This information is being provided to assist in reducing proliferation in the Government

inventory system.