MIL-R-10509-1 Resistors, Fixed, Film High Stability, Style Rn60This specification covers the requirements for style RN60, high stability, film, fixed, resistors. This style is available in characteristics C, D, E and G.

Pages 1 - 2 - 3 - 4 - 5

MIL-R-10509/1M

2.2  Government documents.

2.2.1  Specifications, standards, and handbooks.  The following specifications, standards, and handbooks form a part of this document to the extent specified herein.  Unless otherwise specified, the issues of these documents are those listed in the issue of the Department of Defense Index of Specifications and Standards (DoDISS) and supplement thereto, cited in the solicitation (see 6.2).

SPECIFICATIONS DEPARTMENT OF DEFENSE

MIL-R-10509  -  Resistors, Fixed, Film (High Stability), General Specification for.

(Unless otherwise indicated, copies of the above specifications, standards, and handbooks are available from the Department Automation and Production Service, Building 4D, (DPM-DODSSP), 700

Robbins Avenue, Philadelphia, PA 19111-5094.)

2.3  Order of precedence.  In the event of a conflict between the text of this document and the references cited herein (except for related associated specifications, specification sheets, or MS sheets), the text of this document takes precedence.  Nothing in this document, however, supersedes applicable laws and regulations unless a specific exemption has been obtained.

3.  REQUIREMENTS

3.1  General.  The requirements for acquiring the product described herein shall consist of this document and MIL-R-10509.

3.2  Interface and physical dimensions.  Resistors shall meet the interface and physical dimensions specified on figure 1.

3.3  Power rating.  The power rating shall be 0.125 watt.  For characteristic D, the power rating shall be

0.25 watt.

3.4  Voltage rating.  The maximum continuous working voltage shall not exceed 250 volts.  For characteristic D, the maximum continuous working voltage shall not exceed 300 volts.

3.5  Resistance.  Minimum and maximum resistance values shall be as follows in table I.

TABLE I.  Minimum and maximum resistance.

4.  VERIFICATION

4.1  Sampling and inspection.  Sampling and inspection shall be in accordance with MIL-R-10509.

4.2  Terminal strength.  Direct load shall be applied gradually until the load reaches 2 pounds.

2