MIL-PRF-83530/1C
TABLE I. Rating and characteristics.
Clamping
Nominal
Voltage
Capacitance
Clamping
Energy
voltage at
Tolerance
varistor
rating (V)
at 1 MHz
voltage at
PIN
rating
peak current
(%)
voltage
(pF)
100 A (V)
(joules)
rating (V)
(V)
rms
dc
±10
M83530/1-2000B
200
130
175
50
325
3800
570
M83530/1-2200D
220
+10
-5
150
200
55
360
3200
650
M83530/1-4300E
430
275
369
100
680
1800
1200
+5,
-10
M83530/1-5100E
510
320
420
120
810
1500
1450
4. QUALITY ASSURANCE PROVISIONS
4.1 Sampling and inspection. Sampling and inspection shall be in accordance with MIL-PRF-83530.
4.2 Energy. The test peak current shall be 140 A.
4.3 Clamping voltage. The test current shall be 100 A.
4.4 Pulse life. The test current shall be 250 A.
5. PACKAGING
5.1 Packaging. For acquisition purposes, the packaging requirements shall be as specified in the contract or order
(see 6.2). When packaging of materiel is to be performed by DoD or in-house contractor personnel, these personnel
need to contact the responsible packaging activity to ascertain packaging requirements. Packaging requirements are
maintained by the Inventory Control Point's packaging activity within the Military Service or Defense Agency, or within
the military services system commands. Packaging data retrieval is available from the managing Military Department's
or Defense Agency's automated packaging files, CD-ROM products, or by contacting the responsible packaging
activity.
6. NOTES
(This section contains information of a general or explanatory nature that may be helpful, but is not mandatory.)
6.1 Notes. The notes specified in MIL-PRF-83530 are applicable to this specification.
6.2 Changes from previous issue. Marginal notations are not used in this revision to identify changes with respect
to the previous issue due to the extensiveness of the changes.
6.3 Tin whisker growth. The use of alloys with tin content greater than 97 percent, by mass, may exhibit tin
whisker growth problems after manufacture. Tin whiskers may occur anytime from a day to years after manufacture
and can develop under typical operating conditions, on products that use such materials. Conformal coatings applied
over top of a whisker-prone surface will not prevent the formation of tin whiskers. Alloys of 3 percent lead, by mass,
have shown to inhibit the growth of tin whiskers. For additional information on this matter, refer to
ASTM-B545 (Standard Specification for Electrodeposited Coatings of Tin).
6.4 Changes from previous issue. The margins of this specification are marked with vertical lines to indicate where
changes from the previous issue were made. This was done as a convenience only and the Government assumes no
liability whatsoever for any inaccuracies in these notations. Bidders and contractors are cautioned to evaluate the
requirements of this document based on the entire content irrespective of the marginal notations and relationship to
the last previous issue
4