MIL-PRF-83401-15 Resistor Network, Fixed, Film, Style Rz150, 14 Pin Flat PackThis specification covers the associated requirements for style RZ150, 14 pin flat pack resistor networks. This style is available in all characteristics and all resistance tolerances. This specification has two product levels, a high reliability, 100 percent burn-in screened "M" part number level and nonburn-in screened part number "C". Designers are CAUTIONED on using these resistors in high power pulses applications \(see 6.4\).

Pages 1 - 2 - 3 - 4 - 5 - 6

MIL-PRF-83401/15B

2. APPLICABLE DOCUMENTS

2.1 General. The documents listed in this section are specified in sections 3 and 4 of this specification. This

section does not include documents cited in other sections of this specification or recommended for additional

information or as examples. While every effort has been made to ensure the completeness of this list, document

users are cautioned that they must meet all specified requirements documents cited in sections 3 and 4 of this

specification, whether or not they are listed.

2.2 Government documents.

2.2.1 Specifications, standards, and handbooks. The following specifications, standards, and handbooks form a

part of this document to the extent specified herein. Unless otherwise specified, the issues of these documents are

those listed in the solicitation or contract.

DEPARTMENT OF DEFENSE SPECIFICATIONS

Resistor Networks, Fixed, Film, and Capacitor-Resistor Networks, Ceramic

Capacitor and Fixed, Film, Resistors, General Specification for.

(Copies of these documents are available online at https://assist.daps.dla.mil/quisksearch/ or

https://assist.daps.dla.mil or from the Standard Document Order Desk, 700 Robbins Avenue, building 4D, Philadelphia,

PA 19111-5094.)

2.3 Order of precedence. In the event of a conflict between the text of this document and the references cited

herein, the text of this document takes precedence. Nothing in this document, however, supersedes applicable laws

and regulations unless a specific exemption has been obtained.

3. REQUIREMENTS

3.1 Associated specifications. The individual item requirements shall be in accordance with MIL-PRF-83401, as

specified herein.

3.2 Interface and physical dimension. The resistor shall meet the interface and physical dimensions specified on

3.2.1 Internal connection. Internal connections shall be accomplished by thermal compression bonding of gold to

gold, to form a solid phase weld from the lead to the internal resistor connection. No solder connection, eutectic or

noneutectic, shall be permitted in this construction.

3.3 Power rating (70�C). The power ratings for schematics A, B, and J shall be as specified in table II.