MIL-PRF-55342-8 Resistors, Chip, Fixed, Film, Nonestablished Reliability, Established Reliability, Space Level, Style Rm2010This specification covers the requirements for style RM2010, fixed, film, chip, nonestablished reliability, established reliability, and space level resistors. This style is available in characteristic H, characteristic E, characteristic K, characteristic L, and characteristic M, resistance tolerances .1 percent, .25 percent, .5 percent, 1 percent, 2 percent, 5 percent, and 10 percent, and all termination materials. Designers are CAUTIONED on using these resistors in high power pulses applications \(see 6.5\).

Pages 1 - 2 - 3 - 4 - 5

MIL-PRF-55342/8E

2.2 Government documents.

2.2.1 Specifications, standards, and handbooks. The following specifications, standards, and handbooks forms a

part of this document to the extent specified herein. Unless otherwise specified, the issues of these documents are

those cited in the solicitation or ocntract.

DEPARTMENT OF DEFENSE SPECIFICATION

MIL-PRF-55342 - Resistors, Chip, Fixed, Film, Nonestablished Reliability, Established Reliability, Space Level,

General Specification for.

(Copies of these documents are available online at https://assist.daps.dla.mil/quicksearch/ or

www.dodssp.daps.mil or from the Standardization Document Order Desk, 700 Robbins Avenue, Building

4D, Philadelphia, PA 19111-5094.)

2.3 Order of precedence. In the event of a conflict between the text of this document and the references cited

herein (except for related associated specifications, specification sheets, or MS standards), the text of this document

takes precedence. Nothing in this document, however, supersedes applicable laws and regulations unless a specific

exemption has been obtained.

3. REQUIREMENTS

3.1 General. The requirements for acquiring the product described herein shall consist of this document and MIL-

PRF-55342.

3.2 Interface and physical dimensions. Resistors shall meet the interface and physical dimensions specified on

figure 1, as applicable.

3.3. Power rating. The power ratings in milliwatts for characteristic H, characteristic E, characteristic K, and

characteristic M relative to the associated test board shall be as follows:

Fiber board

Ceramic board

Characteristic

H and E

400 mW

K and M

600 mW

800 mW

3.3.1 Power rating (power conditioning test). The power conditioning test for space level parts shall be based on

the power rating of fiber boards (see 3.3).

3.4 Voltage rating. The maximum continuous working voltage shall not exceed 150 volts.

3.5 Resistance and resistance tolerance. Minimum and maximum resistance values and associated resistance

tolerances shall be as listed in table I.