MIL-PRF-55342-2 Resistors, Chip, Fixed, Film, Nonestablished Reliability, Established Reliability, Space Level, Style Rm0505This specification covers the requirements for style RM0505, fixed, film, chip, nonestablished reliability, established reliability, and space level resistors. This style is available in characteristic H, characteristic E, characteristic K, characteristic L, and characteristic M, resistance tolerances .1 percent, .25 percent, .5 percent, 1 percent, 2 percent, 5 percent, and 10 percent, and all termination materials. . Designers are CAUTIONED on using these resistors in high power pulses applications \(see 6.5\).

Pages 1 - 2 - 3 - 4 - 5

MIL-PRF-55342/2J

2.2 Government documents.

2.2.1 Specifications, standards, and handbooks. The following specifications, standards, and

handbooks forms a part of this document to the extent specified herein. Unless otherwise specified, the

issues of these documents are those cited in the solicitation or contract.

DEPARTMENT OF DEFENSE SPECIFICATION

MIL-PRF-55342 - Resistors, Chip, Fixed, Film, Nonestablished Reliability, Established Reliability,

Space Level, General Specification for.

(Copies of these documents are available online at https://assist.daps.dla.mil/quicksearch/ or

www.dodssp.daps.mil or from the Standardization Document Order Desk, 700 Robbins Avenue, Building

4D, Philadelphia, PA 19111-5094.)

2.3 Order of precedence. In the event of a conflict between the text of this document and the

references cited herein, (expect for related associated specifications, specification sheets or MS

standards), the text of this document takes precedence. Nothing in this document, however, supersedes

applicable laws and regulations unless a specific exemption has been obtained.

3. REQUIREMENTS

3.1 General. The requirements for acquiring the product described herein shall consist of this

document and MIL-PRF-55342.

3.2 Interface and physical dimensions. Resistors shall meet the interface and physical dimensions

specified on figure 1, as applicable.

3.3. Power rating. The power rating for characteristic H, and characteristic E shall be 25 milliwatts.

For characteristic K and characteristic M, the power rating shall be 50 milliwatts.

3.4 Voltage rating. The maximum continuous working voltage shall not exceed 40 volts.

3.5 Resistance and resistance tolerance. Minimum and maximum resistance values and associated

resistance tolerances shall be as listed in table I.