INCH-POUND
MIL-PRF-27208/8H
11 October 2006
SUPERSEDING
MIL-PRF-27208/8G
13 June 2001
PERFORMANCE SPECIFICATION SHEET
RESISTORS, VARIABLE, WIRE WOUND,
(ADJUSTMENT TYPE, LEAD SCREW ACTUATED),
STYLE RT12
This specification is approved for use by all Departments
and agencies of the Department of Defense.
1. SCOPE
1.1 Scope. This specification covers the requirements for style RT12 adjustment type, lead screw actuated, wire
wound, variable resistors.
*
1.2 Part or Identifying Number (PIN). Resistors covered by this specification are identified by a PIN
which consists of a basis style and a coded number. The PIN is in the following form:
RT12
C2P102
⏐
⏐
⏐
⏐
Style
Coded number
(see MIL-PRF-27208)
2. APPLICABLE DOCUMENTS
2.1 General. The documents listed in this section are specified in sections 3 and 4 of this specification. This
section does not include documents cited in other sections of this specification or recommended for additional
information or as examples. While every effort has been made to ensure the completeness of this list, document
users are cautioned that they must meet all specified requirements documents cited in sections 3 and 4 of this
specification, whether or not they are listed.
Comments, suggestions, or questions on this document should be addressed to: Defense Supply Center,
Columbus, ATTN: DSCC-VAT, Post Office Box 3990, Columbus Ohio 43218-3990, or emailed to
resistor@dla.mil. Since contact information can change, you may want to verify the currency of this
address information using the ASSIST Online database at https://assist.daps.dla.mil.
AMSC N/A
FSC 5905
For Parts Inquires call Parts Hangar, Inc (727) 493-0744
© Copyright 2015 Integrated Publishing, Inc.
A Service Disabled Veteran Owned Small Business