MIL-PRF-22684 Resistors, Fixed, Film \(Insulated\) General Specification ForThis specification covers the general requirements for insulated, film, fixed resistors of 2- and 5- percent resistance tolerance. These resistors are capable of full-load operation at an ambient temperature of 70 degrees C and have a resistance-temperature characteristic of +200 parts per million per degree Celsius \(ppm/degrees C\), \(see 6.1\). Designers are CAUTIONED on using these resistors in high power pulse applications \(see 6.10\).

Pages 1 - 2 - 3 - 4 - 5 - 6 - 7 - 8 - 9 - 10 - 11 - 12 - 13 - 14

INCH-POUND

MIL-PRF-22684F

13 February 2006

SUPERSEDING

MIL-PRF-22684E

24 September 1999

PERFORMANCE SPECIFICATION

RESISTORS, FIXED, FILM (INSULATED)

GENERAL SPECIFICATION FOR

This specification is approved for use by all Departments

and Agencies of the Department of Defense.

1. SCOPE

1.1 Scope. This specification covers the general requirements for insulated, film, fixed resistors of 2- and 5-

percent resistance tolerance. These resistors are capable of full-load operation at an ambient temperature of 70�C

and have a resistance-temperature characteristic of +200 parts per million per degree Celsius (ppm/�C), (see 6.1).

1.2 Classification.

1.2.1 Part or Identifying Number (PIN). Resistors specified herein are identified by the PIN which consists of the

basic number, associated specification, and a coded dash number.

M22684/08-

1001

│

Basic and associated

Coded dash number

specification number

1.2.1.1 Coded dash number. The coded dash number is a coded value which identifies the resistance value,

resistance tolerance, and the terminal (see 3.1).

2. APPLICABLE DOCUMENTS

2.1 General. The documents listed in this section are specified in sections 3, 4, and 5 of this specification. This

section does not include documents cited in other sections of this specification or recommended for additional

information or as examples. While every effort has been made to ensure the completeness of this list, document

users are cautioned that they must meet all specified requirements documents cited in sections 3, 4, and 5 of this

specification, whether or not they are listed.

Comments, suggestions, or questions on this document should be addressed to: Defense Supply

Center, Columbus, ATTN: DSCC-VAT, Post Office Box 3990, Columbus, Ohio 43218-3990, or

emailed to resistor@dla.mil. Since contact information can change, you may want to verify the

currency of this address information using the ASSIST Online database at https://assist.daps.dla.mil.

AMSC N/A

FSC 5905